Unfortunately, we often get the call after the client has run off in the wrong direction, sometimes disastrously so. F is generated when the drive takes the information from the Heidenheim style feedback and does an overall summing of the signal. If the signal summation comes in between 1v and If the signal is outside of these bounds, it triggers the F error code.
|Published (Last):||26 October 2011|
|PDF File Size:||2.88 Mb|
|ePub File Size:||9.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
Manual Request Support When you need support with Indramat, is the only number you need to call. Evaluation and measurement Remanufacturing Retrofitting Unlike the typical third-party supply house, we can offer preventive inspection and maintenance, measurement of operating parameters, and design and installation assistance.
Original parts and standardized procedures make factory repairs far superior to third-party attempts. Remanufacturing includes replacement of all wearing parts, cleaning, and testing. We also have the largest supply of emergency replacement units in the nation, ready for delivery while your units are being remanufactured.
There are times when there is no substitute for on-site support. We have Factory Service Engineers available for those times when nothing else will do. Charter flights are available for quick response. We know that a problem with your Indramat drives, controls, or motors is a serious problem for your business. Our highest priority is to get you back up and running as fast as possible.
Call us now. Hyperdyne Systems, Inc.
The API uses the reply telegram to extract the required data or identifies potentials errors and provides it back to the user. Drive modes The API is designed to support two dedicated drive modes: Speed Control Speed Control The principle of the Speed Control is depicted below: Basically, Speed Control offers non-realtime-capable way to quickly setup a new kinematic point controlled via speed and acceleration. Based on the requested speed and acceleration, the motor connected to the Indradrive system is cranking or down to the respective kinematic point. The time between providing the data to the API and reaction of the motor depends on the Operating System most likely Windows , calculation and creation of the SIS telegram and the baudrate to transfer the telegram. The time to go from the current kinematic point to the requested kinematic point can be determined as the following: whereas the difference between current and targeted speed. Remarks The Speed Control drive mode cannot be used for real-time applications, since the jitter caused by OS and telegram transmission is unpredictable. Use the Sequencer drive mode for real-time applications instead.
INDRADRIVE INSTALLATION MANUAL PDF
KCU02 Control Electronics
Rexroth IndraDrive Manuals